OK couplings
When OK couplings are used for shaft connections, the powerful oil injection method is utilized.
Shaft preparation is simple. No keyway to machine, no taper and no thrust ring. When mounting an OK coupling, the thin inner sleeve with a tapered outside diameter slides onto the shaft. A thick outer sleeve with a matching tapered inner surface fits over the inner sleeve. Ordinary mineral oil is then injected between the sleeves. An integrated hydraulic connection drives the outer sleeve up the taper of the inner sleeve.
When the outer sleeve reaches its final position, an interference fit is created - just as if the outer sleeve had been heated and shrink-fitted. But no heat is required, and the coupling can be removed just as easily as it was installed.
This powerful use of friction enables the OK coupling to transmit torque and axial loads over the entire shaft area. There are no stress raisers from keyways, and no fretting under high shock or reversing loads.
Very large couplings that previously could only be shrink-fitted after heating can now be installed cold using the OK method.